Motor - Stepper Motors

OpenELAB CNC shield V4 is used as driving shield for engraving machines, fully compatible with NANO control board . So you just need to stack the Nano board onto the shield when using. It has total 3-way pin slots for stepper motor drive modules (Not...

This stepper motor driver is powered by A4988, a DMOS microstep driver with converter and overcurrent protection. It is available in full, half, 1/4, 1/8 and 1/16 stepping modes to operate bipolar stepper motors with output drive performance up to 35 V and ±...

Ready soldered stepper motor with multiple applications e.g. at your makerbot duo clone or also at the microcontroller. Directly with heat sink ex works, therefore no overheating of the product.✔️ Ideal for controlling your stepper motors for 3D printers or CNC machines e.g. via...

Rated Voltage: DC5V4-phaseReduction Ratio: 1/64Step Torque Angle: 5.625/64DC Resistance: 200±7% (25)Insulation Resistance: >10M (500V)Dielectric Strength: 600V AC / 1mA / 1sInsulation Grade: ANo-load Pull in Frequency: >600HzNo-load Pull out Frequency: >1000HzPull in Torque: >34.3mN.m(120Hz)Detent Torque: >34.3mN.mTemperature Rise: <40K(120Hz)Noise: <40dB (120Hz, No load, 10cm)Board Size:...