Holybro PM02 V3 Power Module 12S

🏭 Product Inventory Location: China

€33,47 EUR
€33,47 EUR
€33,47 EUR
Please hurry! Only 2000 left in stock
Subtotal: €33,47

Free Shipping from 30€ in Germany, 50€ in the EU & US!

- All products are tax-inclusive.

- EU Countries & US Delivery Time: 2 weeks.

- Other Countries Delivery Time: 2.5 ~ 3 weeks.

Holybro PM02 V3 Power Module 12S - OpenELAB

Holybro PM02 V3 Power Module 12S

€33,47

Holybro PM02 V3 Power Module 12S

€33,47

This PM02 Power Module provides a simple way to supply regulated 5.2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable. It comes with pre-soldered wires, capacitor, and XT60 connector on both ends, along with shrink tubing on the PCBA for physical protection.

 

Specification:

  • Input Voltage: 2S-12S
  • PCB Cont. Current Rating: 60A
  • PCB Burst Current Rating: 100A (<60 Sec)
  • Max Current Sensing: 120A
  • Output: DC 5.2V & 3A Max
  • Voltage Divider: 18.182
  • Amperes per Volt: 36.364 
  • Weight: 20g

Please Note:

- The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. 
- This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D). 

 

Package Includes:

- 1x Power Module with XT60 Connectors Board (pre-soldered)
- 1x Electrolytic capacito: 220uF 63V (pre-soldered)
- 1x Molex 6 Position Connector 15 cm
- 1x JST GH 6 Position Connector 15 cm 

Setup guide for PX4 & Ardupilot can be found in the Holybro Doc here.

Related Products

Recently Viewed Products