The new MKS Base 1.2 3D Printer Controller board combines and improves the assets of the RAMPS 1.4 and Arduino Mega 2560 boards on a fantastic single board solution. The MKS Base 1.2 is an optimal 3D printer controller solution for your Reprap 3D Printer.
Features
-
The MKS Base 1.2 solves interface connection problems between the Arduino Mega 2560 and RAMPS 1.4 boards by having both integrated into a single board
-
5 Stepper Motor Driver Slots. The boards supports a wide variety of Stepper Motor Drivers - most notably A4988, DRV8825 and Ice-Blue Stepper Motor drivers drive
-
The MKS Base 1.2 board uses a high quality 4-layer PCB which optimizes heat dissipation
-
Firmware can use the same configuration as RAMPS 1.4
-
Easy DISPLAY + SD-CARD connector - compatible pin header on board for 12864 & 2004 LCD Display controller panels.
-
6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
-
3 x 5V output, 3 x Power voltage output
-
Reserve motor pulse and direction output port
-
Support 12V-24V power input